80M DIPOLE ANTENNA KIT

*** TO BUY WITH CONFIDENCE, YOU ARE GETTING PAYPAL PROTECTION ! ***  

75 USD SHIPPED ONLY !!

This is the ONE single 80 meters (3.5 - 3.9 MHz) band Dipole antenna kit.

This Dipole Antenna kit includes:

1. Balun 1:1 (1000 W max power, SO-239 connector).
2. TWO pieces of 22 meters of the special antenna insulated copper wires.
3. Four of the TILLER CABLE CLAMPS.
4. TWO of the Ceramic Egg Insulators.

There is the rigit strong waterproof 1:1 Balun with SO-239 female connector you would connect any lenght of 50 ohm cable to. To both sides of the balun connects a couple of the very strong special antenna insulated copper wires with a few steel threads inside the insulation. We are including these wires of about 1 meter more of length than it is necessary to have it on 80m band. So you can ajust the resonant frequency cutting the ends of each wires equally off to get the frequency where the dipole would have minimal SWR. Resonant frequency depends of position of the dipole above the ground. Then you place the Ceramic Egg Insulators on both wires ends.

And of course than high above the ground your antenna is placed then better it works.

To see more pictures of this dipole there. There you find a few which show the assembled dipole.

Technical data:

Band of operation - 80m
SWR - 1:1 to 1:1.3 (depending of freq and height of the antenna above ground)
TX Power - 800 W CW, 1000 W SSB
Size of the balun - 19 cm x 8 cm
Length - 43 m (depending of resonant freq)
Weight - 1.3 kg

 

We take PayPal and you can pay pushing "Buy Now" button.

Click the button below and buy the 80M Dipole Antenna Kit for 55 USD + 20 USD shipping.

 

Pay for your item