148/28 MHZ TRANSVERTER BOARD WITH CRYSTAL LO

*** TO BUY WITH CONFIDENCE, YOU ARE GETTING PAYPAL PROTECTION ! *** 

With this transverter board you can work on 2 meters band using any type of the HF radio that has 10 meters band. It would work the whole 2m band at 146 to 150 MHz if your base radio has 26 to 30 MHz band. Most HF radios have 28 to 30 MHz band so in this case it means you would have 148 to 150 MHz band. It works any modes such SSB, CW or FM if its available in your radio.

Click on this pic to get it large

Driving this transverter board by 1 to 50 mW (0.05 W Max) from your 10m band radio you get about 10 - 15 W output power on 8m band. You can adjust input driving power by RV1 pot on the board. This low level input driving power allows to use this transverter board through the low level transverter output of HF radios or with Flex Radios and other type of SDR Radios.

If you are going to use this transverter board driving it by 1 to 10 W power through the Antenna Output of your radio then you would additionally need the Attenuator Board. We offer the Attenuator Board along with the Transverter Board for a lower price than buying them separatelly.

This model of 148/28 MHz Transverter board allows you additionally use the separate RX/TX outputs of your base 28 MHz radio.

Click on this pic to get it large

We are offering completely built and tested in our lab board. To get it worked with your radio perfectly you have to do some soldering works with the cables, wires and connectors.

We are including a circuit of a simple attenuator board which contains a few resistors and relays only. It can be easily built by any person with a basic knowledge in electronics. Also there you find a circuit of a possible connection of this transverter board to your HF radio.

Technical specifications

RF range - 146 ... 150 MHz
IF range - 26 ... 30 MHz (148.000 MHz at 28.000 MHz)
IF input power - 1 ... 50 mW (0.05 W max.) or 0 ... 17 dBm
LO frequency - 120 MHz (3rd overtone of 40.000 MHz crystal)
LO frequency stability - +/- 5 ppm
Output power - 10 ... 15 W
RX gain - typ. 20 dB
Noise figure - typ. 1.0 dB
Image rejection - typ. 70 dB
PTT control - Contact closure to ground
Supply voltage - +13.8 V DC (+12 ... 14 V DC)
Current consumption - typ. 2 A (TX)
TX Output transistor - RD15HVF1
RX Input transistor - BF998
Dimensions (mm) - 80 x 45

 

Download a copy of the description I am including with the Transverter Board here

The circuit of the simple Attenuator Board is here

I test all transveter boards before putting them in a shipping box.
If you were not satisfied with the transverter then in term of 30 days you can ship it back and I refund you.

 

We take PayPal and you can pay pushing "Buy Now" button.

Click button below and buy the TRANSVERTER BOARD for 28 USD + 7 USD shipping

OR YOU CAN GET TOGETHER

TRANSVERTER BOARD and ATTENUATOR BOARD for 38 USD + 7 USD shipping

148/28 MHz TRANSVERTER BOARD

35 USD

Pay for your item

148/28 MHz TRANSVERTER BOARD

AND ATTENUATOR BOARD

45 USD

Pay for your item